d65
New Member
Posts: 7
|
Post by d65 on Dec 13, 2005 3:21:49 GMT 1
I took apart the extractor to check headspace. Headspace is fine but now I can't figure out how to get the 4 pieces of the extractor back together  Any drawings , directions etc. would be greatly appreciated. After test firing a range report will be provided. TIA |
|
|
|
Post by woodsy on Dec 13, 2005 7:58:07 GMT 1
When you say 4 pieces I take it that you are including the breech block. The extractor assembly consists of 3 pieces: the extractor, stay, & spring. To assemble, hold the breech block upside down, slide the extractor into its groove, put the spring over the stay and clip it behind the extractor with the tapered wedge nearest the bottom edge of the extractor. The whole assembly is a bit unstable until the breech block is fitted back onto the piston, where it is prevented from coming apart.
|
|
d65
New Member
Posts: 7
|
Post by d65 on Dec 15, 2005 4:37:58 GMT 1
pics or drawings please. |
|
d65
New Member
Posts: 7
|
Post by d65 on Dec 22, 2005 19:03:15 GMT 1
Okay, I have the extractor back in the breech block but now have the firing pin still out. How does it install?
|
|
|
|
Post by woodsy on Dec 22, 2005 20:23:06 GMT 1
Halfway along the side of the breech block you will find a captive pin which will push easily to one side. Push the pin across and drop the firing pin and spring in the hole from the rear. The cross pin is pushed back when the recess on the firing pin shaft lines up with the cross pin hole.
|
|
Any drawings , directions etc. would be greatly appreciated. After test firing a range report will be provided.