|
|
Post by missingsomething on Jun 23, 2008 20:26:51 GMT 1
|
|
|
|
Post by Kev on Jun 23, 2008 21:00:06 GMT 1
Very nice find,do you see many of them in Canada ?
Don't know if you are planning on re-doing the paint work on the cuts but if so it will keep you busy ;D
I just wish they had made them with all the sections on one side.
Look forward to some more pics
|
|
|
|
Post by missingsomething on Jun 24, 2008 13:43:20 GMT 1
Not a lot kicking around. There was a guy here that made 2-3 himself and was trying to sell them as original. There are a few original Inglis ones but this is the first Enfield one I have seen over here. And the price was OK so I couldn't resist.
|
|
|
|
Post by missingsomething on Jun 25, 2008 23:06:52 GMT 1
|
|
|
|
Post by Kev on Jun 26, 2008 20:47:26 GMT 1
Very nice,a good find ! Have you taken a Dremel to a mag yet to skeletonise it to go with the Bren ? .JPG) |
|
|
|
Post by missingsomething on Jun 26, 2008 21:30:42 GMT 1
Not yet.... the guy I got it from is suppose to have one but cant find it. Worst case is I get the measurements and make one. Because of our stupid laws it needs to be pinned to 5 otherwise its a prohibited device.
|
|
|
|
Post by Kev on Jun 26, 2008 21:42:23 GMT 1
Would you be able to say load 20 rounds into the mag and then pin at 5 leaving 15 rounds that will not feed above the pin but are visable ?
|
|
|
|
Post by missingsomething on Jun 26, 2008 23:32:53 GMT 1
I don't know how you could do that and still be legal. Maybe if you had 2 followers so that the 15 would be in permanently and only 5 would feed?
|
|
